Jump to content

[Solved] Looking for DDR2 Ram


ricktendo

Recommended Posts

In this case I think I have to disagree with everyone but Rick.  From the pics above, the antenna wires are not connected to anything.  I assume that they are supposed to connect to the wifi card that this is an adapter for, correct?  So without the screws to hold the card firmly to the adapter, the fear is that it will just flop around and possibly short something out?  So what's the problem with just going to a hardware store or electronics store or something and just buying screws, standoffs, nuts, and lock washers of the necessary sizes?  Or, as usual, did I misunderstand again?

 

Cheers and Regards

 

EDIT:

 

Like this:

 

vtb13p7_zps43339bdf.jpg

Link to comment
Share on other sites

They flip up, so they need the screws to keep them in... I was going to use a zip tie but instead I pulled the mounts off an old dead toshiba qosmio and soldered them onto the wifi card adapter

 

1zwc09d.jpg

 

I used a little ghetto ingenuity and used a cigarette lighter to do so :P

 

r1khas.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...